Is it possible to decrease the minimum V.Protect voltage from 2.5V to at least 1.2V or 1V to have posibility discharging AA, AAA, etc accumulator battaries? Is it hardware or software limitation? If software, it easely can be changed by firmware update, am I right?
I purchased CT-3 + SM-LD-00 and so far almost everything is working. One issue i am having is that when i start the load the Ibus value on the PC software and on the CT-3 does not update:
For instance i go to Load Module -> Constant-current Mode -> Load Value = 1.00A -> Load Start. After starting, i can hear the fan blowing and can also see that my supply is outputting a current that is approximately normal for 1A Ibus but the Ibus on the software and CT-3 only shows about 300uA...it is strange.
Is there something i am missing for setup? I noticed on the instillation video they plug in some white cable to the "USB-C Out" port before starting. Do i need to do something like that?
Is it possible it was installed improperly before shipping?
Apologies but i already found the solution and realized i made a silly mistake. I had my external Vbus connected to USB-C Out and not USB-C In. Once i plugged it into the correct port it started working properly. Thanks!
发表于: 12-03-2021 08:07:00
发表于: 27-12-2021 11:16:20
