|
发表于: 29-08-2019 09:41:34
|
显示全部楼层
If you want to read the voltage and current of your device while normal operation, connect the INPUT and the charger with a C-C cable, make sure the PD trigger switch is on the OFF position ,and connect the OUTPUT and your device with another CC cable, if the screen didn't light up, flip one of cable in INPUT/OUTPUT and it should light up.
To use the meter as a trigger (make the charger to output 5V/9V/12V etc.), place the PD trigger switch to ON position, and enter PD trigger (Or QC etc.. for some compatible chargers) mode. Check up the manual for details. |
|