|
发表于: 23-04-2021 11:37:02
|
显示全部楼层
so as not to create unnecessary topics, I will write in this one:
critical requests after some time of use
load module:
- is it possible to reduce the threshold voltage below 2.5V, albeit with a loss of power
- cut-off at a given temperature from an external temperature sensor
there is such a strange thing - if you connect an external load to 0.5A and turn on the internal load one to 1.0A, then in the end, for some reason, it turns out not 1.5A, but 1.2A ...
it would be nice to be able to replace the display of the internal temperature with the temperature from an external sensor on the main screens
it would also be very good to add the temperature from an external sensor to the graph, and it is very necessary to add an offline record to the file
on the oscilloscope, for some reason, the amper line (blue line) always stands at zero
graph:
- make sure that the resolution (s / div) is not reset when leaving the graph
- or increase the scanning time, that more time fit on the whole screen, 1 hour or even more (for example, 0.1-10 spm - sample per minutes)
[and then, so that the data is written, even if we are out of the graph]
- or the ability to display on the built-in chart what is written to the 'offline records' file, approximating it to fit into the chart
[or a separate recording option, especially for the internal graph]
(as done by 'U2p' USB tester) |
|